Your plumber in Redmond, about 15 minutes out
Education Hill and Grass Lawn ramblers from the 1960s–70s still carry original copper; Overlake condos bring a steady run of disposal, valve, and fixture calls. Redmond wellfield water is naturally soft but iron-rich in pockets — orange staining is usually iron in the supply, not rust in your pipes.
Plumbing Repairs & Service Calls in Redmond
The everyday calls in Redmond — running toilets, dripping faucets, a disposal that quit, a hose bib that split over winter — are the core of what we do. Two-hour arrival windows, flat pricing before we start, parts on the van. Most Redmond repair visits are finished the same day you call.
- Faucet repair and replacement (kitchen, bath, laundry)
- Running or leaking toilets — fill valves, flappers, wax rings, full swaps
- Garbage disposal repair and replacement
- Under-sink leaks, P-traps, supply lines
- Shut-off valves and main shut-off replacement
- Hose bibs and frost-free sillcocks
Plumbing repairs in Redmond, usually fixed on the first visit →
Emergency Plumbing in Redmond
Burst pipe, sewage backing up, a water heater dumping onto the garage floor — Redmond is about 15 minutes from our nearest dispatch point, and we run 24 hours. Shut the main, call, and a licensed plumber is on the road.
- Burst and frozen pipes
- Water heater leaking or flooding
- Sewage backup in tubs, showers, or floor drains
- Main shut-off valve failure
- Slab leaks and hot-spot floors
- Ceiling leaks from upstairs bathrooms
Water Heaters in Redmond
Redmond water heater calls are half repairs and half same-day tank swaps. 40- and 50-gallon units are on the truck; tankless and heat-pump installs are typically next-day pending gas sizing. Permit through the Redmond Development Services is included.
- No hot water diagnosis
- Pilot, thermocouple, and gas valve repair
- Electric element and thermostat replacement
- Leaking tank replacement (same day, 40/50 gal)
- Tankless installation (Navien, Rinnai) and descaling
- Heat-pump water heaters with the PSE rebate paperwork
Drain Cleaning & Hydro-Jetting in Redmond
In Redmond, mature cedar and fir roots in older clay side sewers are the recurring main-line call; kitchen grease is the recurring indoor one. We cable when that will hold and hydro-jet when it will not, then camera the line so the fix sticks.
- Bathroom sink, tub, and shower drains
- Kitchen line grease clogs
- Toilet clogs and auger service
- Main sewer line cabling
- Hydro-jetting (4,000 psi) for grease, scale, and roots
- Sewer camera inspection with emailed video
Drain cleaning in Redmond, from a slow tub to roots in the main line →
Sewer Line Repair in Redmond
Side sewers in Redmond are the homeowner's responsibility to the main, and permits go through the Redmond Development Services. We camera and locate first, spot-repair when it is one bad section, and line or burst when the whole run has failed.
- Camera inspection and locating
- Spot repairs (one dig, one section)
- Cured-in-place pipe (CIPP) lining
- Pipe bursting for full replacement
- Side sewer permits and city inspection
- Cleanout installation
Sewer line repair in Redmond, trenchless where it makes sense →
Repiping in Redmond
In Redmond, repiping is usually a partial job — the hot side of a 1960s copper house or the crawlspace runs of a 1980s build — rather than the whole house. We pressure-test and quote the zone that is actually failing.
- Pinhole leak assessment and partial repipes
- Polybutylene (grey pipe) replacement
- Galvanized supply line replacement
- Whole-home copper (Type L) or PEX-A
- Crawlspace and attic runs
- Main water line from meter to house
Permits in Redmond
Water heater, sewer, and repipe work needs a plumbing permit from the Redmond Development Services. We pull it and schedule the inspection; it is in the flat-rate quote. Repairs and drain cleaning do not need one.
From The 3-Day Drip
Nearby
Plumber in Kirkland · Plumber in Woodinville · Plumber in Bellevue · Plumber in Sammamish · Plumber in Newcastle