Drain cleaning in Sammamish, from a slow tub to roots in the main line
A slow bathroom sink is a 30-minute service call. A kitchen line that backs up every few months is grease, and cabling only pokes a hole through it. A main line that gurgles after a rain is roots. We match the tool to the problem and run a camera afterward so you are not paying for the same clog twice.
What we handle
- Bathroom sink, tub, and shower drains
- Kitchen line grease clogs
- Toilet clogs and auger service
- Main sewer line cabling
- Hydro-jetting (4,000 psi) for grease, scale, and roots
- Sewer camera inspection with emailed video
- Floor drain and laundry standpipe backups
- Root intrusion in clay and concrete side sewers
What's different in Sammamish
Mostly 1990s–2010s construction: PEX and copper in good shape, but PRVs, expansion tanks, and original water heaters are all reaching replacement age together.
Sammamish Plateau Water comes from deep wells and runs moderately hard, so scale on tankless heat exchangers and mineral crust on faucet aerators are the routine calls. Permits, when needed, go through the Sammamish Permit Center; we pull them.
Cable vs. jetter
A cable machine clears the blockage in front of it and is right for hair, a toy, a one-time clog. A hydro-jetter scours the entire pipe wall back to bare pipe, which is what recurring grease and root problems need. We start with the cheaper tool when it will actually hold.
Why we camera after
Because "the water went down" is not the same as "the pipe is clear." A camera pass shows bellies, offsets, cracked clay, or an Orangeburg line that is about to collapse. You get the video. If there is a real defect, that is where trenchless repair comes in — but you decide with the footage in hand.
Questions we get in Sammamish
Will jetting damage old pipes?
We camera first and set pressure to the pipe material. Badly cracked clay or Orangeburg gets lining, not jetting.
How often should I jet a main line with roots?
Every 12–18 months as maintenance until you are ready to line it. Lining ends the cycle.